Space for 15 plug-in cards.
Accepts cards of type:
-Loop-U3510 rack card (G.703-64Kbps)
-Loop-E1510 rack card
DC power redundancy card holder of the point-to-point CSU/DSU devices at the central office. It's a low-cost derivative of the Loop-C5400. The type of plug-in card can be either the low-cost non-manageable card or the managed card. The plug-in cards with different type can be mixed together.
The C-5400 serves as a collection of stand-alone devices at the central office. Each line card is equivalent to a stand-alone CSU/DSU device. No traffic flow between cards on this system.
By offering point-to-multiple-point leased line service, the C-5400 is a perfect solution to the DDN and internet network.
To specify options, choose from list below:
y Hot pluggable plug-in cards
y 15 slots for the general-purpose plug-in cards
y Each line card is fully independent
y DC Power Redundancy
y Single alarm status output, from each line cards and power cards, is available to the power card and Controller card for the system alarm monitoring
y Anti-copy Circuit should be added in every card types
Front Panel
y LED display and Dip-switch are available on the front side of the shelf
y System Alarm Cut-off (ACO) is available on the power card and the ACO push-button is located on the front side. Any ACO button pushed will be enough to cut off the alarm
y Line interface connectors are available on the rear side of the shelf
y Support Hot-pluggable
y Support LED indicators and Alarm cut-off (ACO)
y Load sharing between the primary and redundant power cards
y Input protection shall be provided in case of wrong polarity of /48V input.
y Output protection against short circuit and over-load conditions shall be provided. In that case, the protection circuit should shut down the outputs to prevent damaging the external circuits.
y Up to 120 Watt
y Wide-range DC input voltage: -48VDC
y Output voltage: 5V
y Operating environment temperature: 0°C to 50°C
y Anti-copy circuit should be added on the power card
y Mini-packs II connector to the backplane
Dimensions 438x176x290 mm (WxHxD) each rack cage can have 15 plug-in cards and 2 power modules
Power (DC) 48 Vdc, 2-3 watts per card
Temperature 0 - 50°C
Humidity 0 - 95% RH(non-condensing)
Mounting Desk-top stackable, 19/23 inch rack mountable
Application Illustrations
Subject to change without notice