E3 Interface Card for Loop-V 4200-28 Features
Loop Telecom's E3 plug-in card is a module designed for the Loop-V 4200-28 Integrated Multiservice Access Platform (IMAP). The E3 card is used to terminate a E3 line and separate the E3 signal into up to 16 E1 signals. For redundancy, 1 + 1 protection can be obtained by using two cards.
Full time slot interchange is available, as any time slot, or block of time slots, from any incoming low-speed device can be mapped to any one of the E1 contained within the E3.
Multicolor LEDs provide status indication for power/standby, LOS, LOF and test. Internal firmware is stored in flash memory so that future software upgrades can be downloaded.
The Loop-V 4200 series supports local control and diagnostics by using a VT-100 terminal connected to the console port. The Loop-V 4200 series also supports Ethernet, Telnet, and SNMP, so that it can be controlled and diagnosed from remote locations.
Ordering Information
Optional Redundancy 1 + 1 Protection Data Rate 34.368 Mbps ± 20ppm Line Code B3ZS Connector BNC Impedance 75 Ohm Coax LED Four LEDs indicate the status of ACTIVE, LOS, LOF and TEST. Cable Compensation 0 to 900 feet. Framing ITU G.751 Output Mask ITU G.703 Jitter ITU G.823
Application Illustration
Loop-V 4200-28